Structured cabling and WiFi designed for how Arcadia teams actually work.
Access points, switches, and structured cabling designed around your Arcadia building's real construction and layout, not a generic router placement.
Arcadia sits at the base of the San Gabriel foothills, close to our Alhambra shop, with a mix of established single-family neighborhoods and commercial stretches along Huntington Drive and Baldwin Avenue. Many properties near the Santa Anita area sit close to wildland-urban interface zones, which is worth factoring into any system design here.
A Fluke tester confirming a 267 ft CAT6 run at an Arcadia, CA property, with all 8 pins matching end to end before the cable is put into service.
Do you install fiber optic cabling, not just copper?
Yes. We install fiber for backbone and long-haul cabling runs, both above and below ground, including direct burial and conduit-rated fiber. We terminate every run in fiber trays using fusion splicers, the same low-loss termination method used in enterprise and carrier networks, rather than cheaper mechanical splices that degrade signal quality over time.
Do you work with builders and general contractors on new Arcadia construction?
Yes, we regularly work directly with builders and GCs to rough in structured cabling during construction for Arcadia projects, before walls are closed up.
Is your WiFi setup a mesh system?
No, we hardwire access points back to a switch rather than relying on wireless mesh hops, which gives Arcadia properties more consistent coverage and bandwidth.